- #Packet tracer activity chapter 5 network security update
- #Packet tracer activity chapter 5 network security verification
- #Packet tracer activity chapter 5 network security password
- #Packet tracer activity chapter 5 network security mac
Configure the IOS IPS to use the signature categories. Configure the IPS signature storage location to be flash:ipsdir.ĬORP(config)# ip ips config location flash:ipsdir/ retries 1ĭ. On the CORP router, create a directory in flash named ipsdir.ī. Step 4: Configure an IOS IPS on the CORP Router.Ī. SW1(config-if-range)# switchport port-security mac-address sticky SW1(config-if-range)# switchport port-security violation shutdown SW1(config-if-range)# switchport port-security maximum 2 SW1(config-if-range)# switchport port-security
#Packet tracer activity chapter 5 network security mac
Allow the MAC address to be learned dynamically and to shutdown the port if a violation occurs. Set the maximum number of learned MAC addresses to 2 on FastEthernet ports 0/1 to 0/23.Configure port security and disable unused ports. SW1(config-if-range)# spanning-tree bpduguard enableĭ. SW1(config-if-range)# spanning-tree portfast Enable BPDU guard on FastEthernet ports 0/1 to 0/23.Configure PortFast on FastEthernet ports 0/1 to 0/23.Configure Switch1 to protect against STP attacks. SW1(config)# storm-control broadcast level 50Ĭ. Enable storm control for broadcasts on FastEthernet 0/24 with a 50 percent rising suppression level.
#Packet tracer activity chapter 5 network security password
Access Switch1 with username CORPADMIN, password ciscoccnas, and the enable secret password of ciscoclass.ī. Step 3: Configure Device Hardening for Switch1.Ī.
#Packet tracer activity chapter 5 network security update
#Packet tracer activity chapter 5 network security verification
Note: Appropriate verification procedures should be taken after each configuration task to ensure that it has been properly implemented.